Scheibner f.e.i.n - Measure the front fork without dismantling
Measure the front fork without dismantling
Determine precisely deviations of the front fork major components, such as distortion of the lower yoke and/or twist of the stanchions. Up to now you probably checked the distortion of the front fork unit by evaluating the rock of a plate on the stanchions.
F.e.in. works with an additional clearance gauge. It provides exact figures of the rock of the precision ground alloy-plate. The optional f.e.in. software provides the necessary calculations based on the measured rock of the plate. You simply compare the results with the tolerances given in the manual to decide the trueness of the yoke and the stanchions. The printout produces a document for the customer. It gives you the opportunity to charge a reasonable price for your job.
Easy to use
- Unfasten the bolts of the upper yoke, the stabiliser and the front wheel axle to release all tension in the front fork
- Turn one stanchion several times and determine the rock of the plate. Transfer the difference between minimum and maximum reading of all measurements of each stanchion to the programme
- If the stanchions are true, take the absolute figure of the rock as reading for the yoke
- Evaluate the results on the screen
Easy handling Windows software
F.e.in. software stores your protocols, does the necessary calculations and the printout of the protocol on your Windows printer.
